Transcend - UTM Activation + Differential Pressure Gauge (WIKA)

Go to "Start"

3. And, if not selected, select the "Asset" option.

4. Select the "Quick Add" option on the right side of the page and click "Tank".

5. Fill up all the Asset details and information.

Note: If you don't have a Site created, click on the "Add" button and fill up the information on the location of the tank.

6. Now, select SENS-1201 0-53" Wika Level (UTM) (Level), SC461A0B0.

7. After that, you just need to add the channel A and the Capacity on your tank in %.

8. To finish this part, select your Event Rules and hit "Save and Close".

9. Now, to insert the Pressure channel, you will need to activate channel B.

10. Go back to the Administration and select Asset.

11. Find your unit.

12. Go to your device and select the Data Channels.

13. On the right side of your screen, click on the option "Add" and "Add Analog Channel".

14. Then, fill up the fields as the image below, specially the sensor template, make sure it is SC461A0B0 - Pressure Transmitter, 400 bar, DIN Connector, ATEX.

15. After this, the unit is ready to be tested and the installation is done.