Transcend - How to Install a DPW900 with a FMR20 Sensor

Then, go to "Start"

3. And, if not selected, select the "Asset" option.

4. Select the "Quick Add" option on the right side of the page and click "Tank".

5. Fill up all the Asset details and information.

Note: If you don't have a Site created, click on the "Add" button and fill up the information on the location of the tank.

6. When you scroll down to the "Tank Details" part, insert the ID Number and select the "Tank Dimensions (volumetrics)"option.

7. After than, click on the option "Add" to add your tank dimensions.

8. After putting the dimensions on the tank and all the other information, make sure you have the strapping chart option ON;

9. Hit "Save and Close" and you should go back to your asset page.

10. Now, select the correct sensor template.

11. When the sensor is selected, make sure you select the unit that you want the tank to read (insWC, Gal US..), the Max Product capacity of the tank, and the Product that you have in the tank.

12. To finalize the installation part, turn on the Event Rules (Alarms) to make sure you receive them when the tank reaches that threshold.

!!Important!! After all this steps, it is essential that you change the Scaled max of the device, because, by default, this units give you a 0-1in span, and that is not correct.

13. For you to change this, make sure you go to "Start" on the top left corner and select the option "Administration" and then "Data Channel".

14. After that, search the unit that you just installed. When you find it, select the "Level" channel.

15. When you see your Data Channel options, you will need to click on the pencil that is on the top right corner of the page.

16. The only thing that needs to be changed in here is the Scaled Max (in).

17. This value needs to be the height of the tank in inches.

18. When finished, click on "Save and Close" and go back to your Data Channel to confirm that the value was changed.

19. When all this steps are done, your install is complete.