Transcend - How to do a New Install - DPW

1. Select the domain that you are installing this unit in.

2. Go to the Menu on the top right corner and select the option "Administration".

3. Click the button "Quick Add" and then Tank.

4. Enter all the information below according to your company's needs.

When selecting a Site/Location, you can always use one that already is on the system, if the tank is on the same location, or you can create one, by clicking the "Add" button.

While in here, you will be prompt to add the Customer Information, Time zone and the Address.

Note: All the information with the "*" symbol, is required to progress forward.

After finishing with all the information, press the "Save and Close" button.

5. On the "Tank Details" part, on the RTU, you will need to insert the ID Number of your Anova Unit, then, select the correct tank type. Select the one that it's the most similar to the one you have.

--This Part is only for volumetrics tanks, if you don't need it, skip to step 6--

Note: Volumetrics is only used if you want to read in any other unit that is not percentage (%) or Inches per Water Column (InsWC). In the case you want to add a tank for those situations, Select the "Set Tank Dimensions (volumetric)" option. Keep in mind you will have to insert the correct tank dimensions (the inner part).

To add Volumetrics, select the option mentioned before and click the button "Add".

Then, just complete the information of the tank, with all the correct dimensions.

Scroll down to the Strapping Chart part. Select the "Use Strapping Chart For Graph" and hit the "Generate Strapping Points" button. (The units are not relevant on this case).

When finished, hit "Save and Close" and you can continue the process.

6. Now, select the correct sensors that you have installed. Keep in mind that this configuration is very important, because if you select the wrong template, it will affect your readings. Insert the Max Product Capacity of the Tank, usually in the unit that you wish to read (insWC, Gal US, Lbs..) and the correct product.

7. To finalize, select the Events. This is the part where you activate the alarms, for your tanks. Select the correct Event Rule Group and insert the values that you want to be your alarms. This can always be edited after.

8. Now that you have all the information, click the "Save and Close" button on the top right corner of your page.