Transcend - How to do a New Install - UTM

1. Select the domain that you are installing this unit in.

2. Go to the Menu on the top right corner and select the option "Administration".

3. Click the button "Quick Add" and then Tank.

4. Enter all the information below according to your company's needs.

When selecting a Site/Location, you can always use one that already is on the system, if the tank is on the same location, or you can create one, by clicking the "Add" button.

While in here, you will be prompt to add the Customer Information, Time zone and the Address.

Note: All the information with the "*" symbol, is required to progress forward.

After finishing with all the information, press the "Save and Close" button.

5. On the "Tank Details" part, on the RTU, you will need to insert the Serial Number of your Anova UTM Unit. Then, select the "Set Tank Dimensions (volumetric) option. Click the "Add" button, to add your new tank.

Note: We recommend to always add a new tank, as if you need to calibrate after, if your tank template is used in more than one unit, it will change the configurations on all of them.

Then, just complete the information of the tank, with all the correct dimensions.

Scroll down to the Strapping Chart part. Select the "Use Strapping Chart For Graph" and hit the "Generate Strapping Points" button. (The units are not relevant on this case).

Important Note: After generating the strapping chart, make sure the "Use Strapping Chart For Graph" option is Deselected.

When finished, hit "Save and Close" and you can continue the process.

6. Now, select the correct sensors that you have installed. Keep in mind that this configuration is very important, because if you select the wrong template, it will affect your readings. Insert the Max Product Capacity of the Tank, usually in the unit that you wish to read (insWC, Gal US, Lbs, %..) and the correct product.

7. To finalize, select the Events. This is the part where you activate the alarms, for your tanks. Select the correct Event Rule Group and insert the values that you want to be your alarms. This can always be edited after.

8. Now that you have all the information, click the "Save and Close" button on the top right corner of your page.