How to send a manual test packet on my unit?

E1xx/E3xx/E6xx Units

To send a test packet on this units, you will need to press the "Fill" and "Mode" buttons at the same time. Then, when you see the message "Diagnostic" or "Diag" on the screen, release both buttons and press the button "Mode" one time until you see "Test" on your screen, then, press the "Fill" button until you see "Idle Slot 1 Test". After that, you can release the button and your test should have started.

FFxx Units

To send a test packet on this units, you need to press both buttons at the same time until you see "Debug" on your screen. When you do, keep pressing the "Fill" Button and release the "Mode" button until you see "Test". When you do, just release the "Fill" button and the test is on its way.

E5xx/FF7F (Explosion Proof Units)

To send a test on this units, you will need a magnet. For the E5xx make sure the magnet goes precisely to the middle, where the small black box is to light up both LED's. You will know that you are doing it right, if both are lit up and the word "Diag" shows on the screen. Then, remove the magnet and put it back close to the right (green) LED until you see "Test", when you do, remove the magnet again and go to the left (red) LED and you should see the word "IDLE" on the screen, if you do, your test has started, if not, repeat the process.

If its a FF7F, make sure the magnet goes precisely to the middle, where the small black box is to light up both LED's. You will know that you are doing it right, if both are lit up and the word "Debug" shows on the screen. Then, just remove the magnet and go to the left (red) LED until you see "TEST" if you do, your test is on the way.

FE Units

To send a test packet on this units, simply click on the green button on the side of the box and keep it clicked until you see the message "Test Call". When you see, release the button and your test should be on its way.

UTM Units

To send a test on this units, you will need to use a magnet. Put the magnet close to the top of the LED's. You should see the top (red) LED lit up. Keep the magnet there until you see the bottom (green) LED light up. When you do, remove the magnet and wait for the unit to communicate.